Dive Rite Classic Primary Reel 250'
The genesis of the Primary Reel began in 1984 when North Florida cave divers needed a reel with 400-feet of line in order to reach the main line in the Devil's cave system at Ginnie Springs. Voila! The Dive Rite Primary Reel was born. Today, divers may choose between our Primary Cave Reel (RE4300) that has 400-feet of braided #24 line and a medium stainless steel bolt snap or our Primary Wreck Reel (RE4310) that has 250-feet of heavier #36 braid line and an extra large stainless bolt snap. These reels position the handle on top, which helps divers who use a handheld light to hold both the light and the reel in one hand, freeing the other hand to work the reel. The frame of the Primary Reel comes with a series of pre-drilled holes so divers can change the handle position from a top-mount handle, to a side-mount handle or a left-hand operated reel. The spool is held in place with a stainless steel "C" clip so replacing the spool or cleaning up a jammed reel is simple.
- DuPont fiber braid line provides strength and minimizes fraying.
- Cave series reels use #24 braid line giving 220-lbs of breakage strength. Wreck series reels use #36 braid line giving 350-lbs of breakage strength.
- Injection molded polycarbonate spools resist breakage and cracking.
- Marine grade stainless steel frame and axle are corrosion resistant.
- Marine grade stainless steel bolt snap is corrosion resistant.
- T-top lockdown screw for easy grip
- Optional drag consists of a black, anodized disk that resists warping and stress on the reel.
- 1.68 lbs (0.76 kg)
- Before diving with a new reel (or a dry reel that has been in storage), put the reel in a bucket of water and after soaking, pay out the entire length of line and reel it back in. This will moisten the line, precluding it from swelling on the reel and further preventing the possibility of jamming or damaging the spool.
- As with most dive equipment, you should rinse your reel with fresh water following each dive. You should also periodically disassemble the reel, and remove any build up of salt or sediment on its internal parts.
- Dive Rite recommends pulling some or all of the line off the spool before each dive, then rewinding it neatly but not too tightly, so as to prevent the possibility of jamming during line deployment.
- Finally, too much line on the spool can cause jams during initial deployment, if you are having a problem with jams try removing 10 or 15 feet of line.